.png)
Caporra Ceiling Hoods Were £999 Now £799 with size options
Extra discounts applied automatically at cart
*Extra discount does not apply to trade accounts*
Luxair offers replacement aluminium grease filters for kitchen extractor fans. These filters are dishwasher-safe—place them upright, like a plate, to effectively remove built-up grease. Avoid using abrasive cleaners, as they can damage both the filters and the cooker hood’s finish.
Please note that filter sizes may vary over time. We can only provide guidance based on current models. To ensure a correct fit, measure your existing filter in millimetres and select the closest matching size from the menu on the left. Product images are for illustrative purposes only; always rely on measurements rather than images when selecting a filter.
Metal grease filters can be placed in your dishwasher upright as you would a plate. This will remove the built up grease. Please do not use abrasive cleaners on either your filters or cooker hood. Using an abrasive cleaning product can tarnish the filters.
The filters must be washed at least one a month with hot water and detergent.
If washing in a dishwasher, make sure to avoid substances with thinners, solvents, hydrochloric acid, bleach, alcohol or abrasive substances. Please do not wash the filters on a temperature higher than 60 degrees.
Avoid alkaline dishwasher detergents (with a pH value higher than 7). Depending on the cleaning agent used, cleaning the filter in a dishwasher can cause permanent discoloration to the surface. However, this will not affect the functioning of the filter in any way. After cleaning, leave the filter to dry on an absorbent surface before putting it back in place.
When your new filter arrives, it may have a blue protective film around the outer edge of the filter, this must be removed by simply peeling it off, it is only there to protect the steel edges from getting scratched in transit.
Filters are not covered by warranty
Each product image displays the exact dimensions of the filter. When selecting your replacement filter, please allow for minor size variations. For example, if your existing filter measures 200mm x 300mm and our filter is 202mm x 298mm, it is likely to still fit your extractor hood.
Use the quick-select chart on the category page to easily find the appropriate size.
Tab Adjustment Instructions
If the filter dimensions are correct but the tab positions differ from your original filter, you can adjust them as follows:
This simple adjustment allows you to customize the filter to match your original fitting.
